1. The electrical part of the distilled water device should be checked regularly and is reliable.
2. The distilled water heater must be operated by a special person. When replacing the new operator, you must explain it in detail.
3. When the user changes the electric heating pipe by themselves due to maintenance, the pads at the joint must be lined with well to ensure that no water is leaking. Otherwise, the head of the electric heating pipe will be penetrated by insulation when power droplets. Tighten the nuts at the head connection of each line, so as not to generate sparks after power -on, and burn the head of the electric heating pipe.
4. When purchasing a distilled water heater, cleaning should be carried out first, and after eight hours of power evaporation, it should be cleaned inside. Then use it officially to ensure that the water quality meets the requirements (cleaning can be performed by 2).
5. Wash the internal inside before use, and exhaust the water deposit, replace fresh water, so as not to reduce the water quality produced and affect the use effect.
6. The impurities in the water source will be left behind after evaporation, especially when the water quality of the tap water is poor and the process is not treated. After evaporation, the sediment will be left in the pot. The inner wall of the shell, the return to the water pipe, etc., accumulate over time, not only hinders the smooth flow of the waterway, but also affects the condensation effect, which will reduce the amount of water production. For the electric heating pipe, it will also bring its heat accumulation to shorten its service life. Therefore, the scale of the above places should be cleared frequently. The method of removing: The scrubbing surface can be used to use a brush to wash a layer of dirt. Please pay attention when washing: Do not be too hard to damage the parts.
7. The heat component of the distilled water heater is an immersive electric heating tube. Its structure is based on the nickel chromium alloy as the heating subject, buried in the center of the copper pipe, and sealing magnesium oxide as an insulation. Therefore, once the water is broken, the heat emitted cannot be absorbed by the water, which will cause the copper tube cover to break and burn. Therefore, it must be immersed in water.
Post time: Nov-30-2023